experiment_picosdr
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| experiment_picosdr [2016/03/22 16:34] – [Setup with GRC] lbeseme | experiment_picosdr [2016/03/22 16:38] – [Setup with GRC] lbeseme | ||
|---|---|---|---|
| Line 41: | Line 41: | ||
| The IP address within CortexLab is 192.168.0.101 for board A, and in case you are using a 4x4 Pico, IP address for board B is 192.168.0.102. | The IP address within CortexLab is 192.168.0.101 for board A, and in case you are using a 4x4 Pico, IP address for board B is 192.168.0.102. | ||
| + | You need initialize both RX and TX path in order to use a card. The order of initialization must be : | ||
| + | * TX card 1 | ||
| + | * RX card 1 | ||
| + | * TX card 2 | ||
| + | * RX card 2 | ||
| + | * custom registers | ||
| #### Radio420 RX | #### Radio420 RX | ||
| Line 54: | Line 60: | ||
| * **RX frequency** -> Baseband frequency. | * **RX frequency** -> Baseband frequency. | ||
| * **Data rate** -> Must twice the sample rate (because of the I/Q signal). | * **Data rate** -> Must twice the sample rate (because of the I/Q signal). | ||
| + | * **Automatic Calibration** -> When automatic calibration is enabled, a calibration algorithm will be run during initialization to minimize LO leakage, IQ gain and phase imbalance. It is recommended to enable it. | ||
| * **Band** -> Must be set regarding your baseband frequency. | * **Band** -> Must be set regarding your baseband frequency. | ||
| * **Update Rate** -> How often to update the gain. This value is in Hertz. | * **Update Rate** -> How often to update the gain. This value is in Hertz. | ||
experiment_picosdr.txt · Last modified: 2016/03/22 18:15 by lbeseme