Differences

This shows you the differences between two versions of the page.

--- fpga_phy_zigbee [2017/12/13 11:59] – [Transmitter] ooubejja
+++ fpga_phy_zigbee [2017/12/13 12:01] – [Transmitter] ooubejja
@@ Line 72: / Line 72: @@
 //If you don't get this part, have a look [[from_gnuradio_to_cortxlab_pico|here]].//
-There isn't that much done in here since all baseband processing is done by the FPGA. All that is left is to connect a ''**File Source**'' block to the ''**RTDEx Sink**'' block, and specify the absolute path to your ".hex" file in ''**File Source**'' block parameters :
+There isn't that much left in here since all baseband processing is done by the FPGA. All you have to do now is to connect a ''**File Source**'' block to the ''**RTDEx Sink**'' block, and specify the absolute path to your ".hex" file in ''**File Source**'' block parameters :
 {{ :filesource.png?400 |}}
-The final flow-graph should look like this :
+The final flow-graph of your transmitter should look like this :
 {{ :ieee802154_tx_pico.grc.png?400 |}}