fpga_phy_zigbee
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| fpga_phy_zigbee [2017/12/13 12:01] – [Transmitter] ooubejja | fpga_phy_zigbee [2017/12/13 12:03] – [Transmitter] ooubejja | ||
|---|---|---|---|
| Line 55: | Line 55: | ||
| * ATTENTION : **Channel** parameter has to be set to **__3__** as in the previous image. That's the only channel that allows access to the custom design. | * ATTENTION : **Channel** parameter has to be set to **__3__** as in the previous image. That's the only channel that allows access to the custom design. | ||
| + | |||
| + | * **Custom Register** (CR 1 & 4) | ||
| + | |||
| + | * Set CR1 value to 0 to enable the transmitter | ||
| + | * Set CR4 value to 0 to disable MIMO synchronization | ||
| * **Radio420 ** | * **Radio420 ** | ||
| Line 65: | Line 70: | ||
| * For the 3 remaining '' | * For the 3 remaining '' | ||
| - | * **Custom Register** (CR 1 & 4) | ||
| - | |||
| - | * Set CR1 value to 0 to enable the transmitter | ||
| - | * Set CR4 value to 0 to disable MIMO synchronization | ||
| //If you don't get this part, have a look [[from_gnuradio_to_cortxlab_pico|here]].// | //If you don't get this part, have a look [[from_gnuradio_to_cortxlab_pico|here]].// | ||
fpga_phy_zigbee.txt · Last modified: 2017/12/14 16:25 by ooubejja