fpga_phy_zigbee
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
fpga_phy_zigbee [2017/12/13 12:03] – [Transmitter] ooubejja | fpga_phy_zigbee [2017/12/14 10:52] – [Download bitstream] ooubejja | ||
---|---|---|---|
Line 21: | Line 21: | ||
We will need some blocks of the module [[https:// | We will need some blocks of the module [[https:// | ||
- | ==== Download bitstream | + | ==== Find the Bitstream |
- | In order to use the FPGA Transmitter design, we will have to load the custom | + | In order to use the FPGA Transmitter design, we will have to load the custom |
- | The receiver node(s) will run the default | + | |
+ | Copy the file in your main directory : | ||
+ | < | ||
+ | you@srvairlock: | ||
+ | </ | ||
+ | |||
+ | //The receiver node(s) will run the default | ||
---- | ---- | ||
Line 62: | Line 68: | ||
* **Radio420 ** | * **Radio420 ** | ||
- | * The Radio420x is a Multimode SDR [[https:// | + | * The Radio420x is a Multimode SDR [[https:// |
- | * It is mandatory to initialize BOTH radio cards, even if only 1 is used. So, since our device contains 2 Radio420M transceivers, | + | * To be short, add 2 '' |
* Now, we only need one transmitter per node, so make sure to enable only the Radio420 TX of Card 1, and set the gain values as following : | * Now, we only need one transmitter per node, so make sure to enable only the Radio420 TX of Card 1, and set the gain values as following : | ||
fpga_phy_zigbee.txt · Last modified: 2017/12/14 16:25 by ooubejja