cortexlab103
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
cortexlab103 [2018/03/26 19:39] – [Observe the result] lcardoso | cortexlab103 [2018/03/30 09:37] – [Setup] mimbert | ||
---|---|---|---|
Line 22: | Line 22: | ||
##Setup | ##Setup | ||
- | The purpose of this tutorial is to receive an ongoing OFDM transmission on a given USRP node. One transmitter node is set up to the whole groupe | + | The purpose of this tutorial is to receive an ongoing OFDM transmission on a given USRP node. One transmitter node is set up for the whole group and each group will control a receiver node. Instead of starting from an empty project, we are going to use the GNU Radio examples for an OFDM transmitter and receiver. We are also going to change the '' |
### Start you virtual FIT/ | ### Start you virtual FIT/ | ||
Line 248: | Line 248: | ||
Go in this folder : | Go in this folder : | ||
< | < | ||
- | you@srvairlock: | + | tuto#@srvairlock: |
- | you@srvairlock: | + | tuto#@srvairlock: |
task_15 | task_15 | ||
- | you@srvairlock: | + | tuto#@srvairlock: |
- | you@srvairlock: | + | tuto#@srvairlock: |
node4.tgz | node4.tgz | ||
</ | </ | ||
Line 259: | Line 259: | ||
< | < | ||
- | you@srvairlock: | + | tuto#@srvairlock: |
- | you@srvairlock: | + | tuto#@srvairlock: |
node4 node4.tgz | node4 node4.tgz | ||
- | you@srvairlock: | + | tuto#@srvairlock: |
- | you@srvairlock: | + | tuto#@srvairlock: |
rx_ofdm.grc | rx_ofdm.grc | ||
rx_ofdm.py | rx_ofdm.py | ||
Line 276: | Line 276: | ||
< | < | ||
- | you@srvairlock: | + | tuto#@srvairlock: |
</ | </ | ||
Line 341: | Line 341: | ||
INFO: Parser returned #f | INFO: Parser returned #f | ||
</ | </ | ||
- | |||
cortexlab103.txt · Last modified: 2018/03/30 09:58 by mimbert