Differences

This shows you the differences between two versions of the page.

--- doc [2019/03/29 10:42] – [USRP] lcardoso
+++ doc [2019/03/29 10:51] – [USRP] lcardoso
@@ Line 41: / Line 41: @@
 * Frequency range: 400 MHz to 4.4 GHz
 * Maximum bandwidth: 20 MHz (but in practice less than 20 MHz are usable without loss of samples due to either the gigabit ethernet connectivity or the computing power of the signal processing computer)
-* Full-duplex TX and RX chains. There are antennas connected to the TX/RX and RX2 ports of all USRPs. In the case the TX/RX ports are used, then only half-duplex is supported
+* Full-duplex TX and RX chains. There are antennas connected to the ''TX/RX'' and ''RX2'' ports of all USRPs. In the case the ''TX/RX'' ports are used, then only half-duplex is supported
-* Synchronization: All USRPs are connected to a stack of octoclocks and can be configured to work in synchronized mode by selecting "external clock source" in the USRP sink or source configuration.
+* Synchronization: All USRPs are connected to a stack of octoclocks and can be configured to work in synchronized mode by selecting ''external clock source'' in the USRP sink or source configuration.
 Find here tutorials on [how to use it](experiment_usrp)