Differences

This shows you the differences between two versions of the page.

--- fftweb [2016/12/13 17:30] – [How to use FFT web] onicolas
+++ fftweb [2016/12/13 17:33] – [How to use FFT Web block] onicolas
@@ Line 7: / Line 7: @@
 ## How to use FFT Web block
-FFT web is a FFT sink block you have to feed with the signal you want to analyse. for example you can put it just ater an USRP Source block to act as a spectrum analyser.
+FFT web is an FFT sink block you have to feed with the signal you want to analyze. For example you can put it just after a USRP Source block to act as a spectrum analyzer.
-FFT Web can be tune with several parameters :
+FFT Web can be tuned with several parameters :
 * **fft_size** The size of the FFT ( 256 is a good start)
 * **power max** The upper limit of the measured power in dB (-30 is a good start)
 * **power min** The lower limit of the measured power in dB (-100 is a good start)
-* **port** The port use to send the data. Usefull when you are using multiple fft web block. (default is 6663)
+* **port** The port used to send the data. Useful when you are using multiple FFT Web blocks. (default is 6663)
 * **frame rate** The frequency of the acquisition (10 is a good start)
-* **samp rate** This correspond to the bandwith of the signal
+* **samp rate** This corresponds to the bandwidth of the signal
 * **ip address** The address of the websocket server the data will be sent to. The address of our server is "srvwww.cortexlab.fr".
-The resolution of graphic will be ''samp rate/fft size''.
+The resolution of the graphic will be ''samp rate/fft size''.
 ## How to see the result