Differences

This shows you the differences between two versions of the page.

--- fpga_phy_zigbee [2017/12/13 12:03] – [Transmitter] ooubejja
+++ fpga_phy_zigbee [2017/12/13 12:05] – [Transmitter] ooubejja
@@ Line 62: / Line 62: @@
  * **Radio420 **
-  * The Radio420x is a Multimode SDR [[https://en.wikipedia.org/wiki/FPGA_Mezzanine_Card|FMC]] RF transceiver. PicoSDR 2x2 contains 2 Radio420M modules which are MIMO capable //(M for MIMO, pretty smart, huh ?)//. Here is a [[https://www.nutaq.com/sites/default/files/Radio420x_V1.3_03_24_2014_web.pdf|product sheet]] for more info.
+  * The Radio420x is a Multimode SDR [[https://en.wikipedia.org/wiki/FPGA_Mezzanine_Card|FMC]] RF transceiver. PicoSDR 2x2 contains 2 Radio420M modules which are MIMO capable //(M for MIMO, pretty smart, huh ?)//. It is mandatory to initialize BOTH radio cards, even if only 1 is used. So, since our device contains 2 Radio420M transceivers, it means we will have 2 ''Radio420 TX'' blocks and 2 ''Radio420 RX'' blocks. Here is a [[https://www.nutaq.com/sites/default/files/Radio420x_V1.3_03_24_2014_web.pdf|product sheet]] for more info.
-  * It is mandatory to initialize BOTH radio cards, even if only 1 is used. So, since our device contains 2 Radio420M transceivers, it means we will have 2 ''Radio420 TX'' blocks and 2 ''Radio420 RX'' blocks
+  * To be short, add 2 ''Radio420 TX'' blocks and 2 ''Radio420 RX'' blocks
   * Now, we only need one transmitter per node, so make sure to enable only the Radio420 TX of Card 1, and set the gain values as following :